Tag Archive for Interface

Interface Specific Configurations

Lab Prerequisites:

  • If you’re using GNS3 than load the Stub Area Networking GNS3 topology than start Router 1.
  • Establish a console session with Router 1.

Lab Objectives:

  • Statically set the speed of interface FastEthernet0/0 to 100.
  • Statically set the duplex of interface FastEthernet0/0 to Full.
  • Configure interface FastEthernet0/0 with an MTU of 1520 bytes.
  • Configure the bandwidth on interface FastEthernet0/0 to 10Mbps.
  • Configure a delay of 10ms on interface FastEthernet0/0.
  • Statically set the MAC address on interface FastEthernet0/0 to ca02.0adc.0ef9.
  • Disable Keepalives on Interface FastEthernet0/0.
  • Disable the Cisco Discovery protocol on interface FastEthernet0/0.

» Read more